Gå til innhold

Kommer ikkje inn i bios engang


10owen

Anbefalte innlegg

Hei

 

Har et merkelig problem som eg ikkje skjønner noe av. Fekk feilmelding på skjermen om at Skjermkortet ikkje fekk riktig strøm, den samme feilmeldingen som dukker opp når man glømmer å sette i PCI-E kontakten.

Slo av maskina og sjekka om allt var ok, og allt var koblet til skikkelig.

Var jo litt bort i ledningene då for å sjekka at de satt skikkelig fast.

Fant ut at allt var iorden og starta opp igjen, MEN MASKINA VIL IKKJE STARTE :cry:

 

Ser at 3 av diagnostic led lysa lyser mens det fjerde blinker, slik står det ei lita stund til maskina piper og så slukner alle ledlysa utenom ett. Har gått over allt og alle kabler, men finner ingen feil, skjønner egentlig ingen ting :blush:

 

Noen her på forumet som har peiling på hva det kan være som er galt ?

 

Poster det her for hovedkortet er et DFI nf4 SLI-DR, skjermkortet er et MSI 6800 GT Prosessor er OPTY 165.

 

Er takknemlig for alle svar..

Lenke til kommentar
Videoannonse
Annonse

Hei

 

Det er nok skjermkortet som er kaputt, har satt i et gammalt PCI kort og da virker allt greit.Skjønner ikke hvorfor det er gåent, har ikkje hatt det så lenge, får sjå om eg får tak i kvittering og prøve å få noe på garantien.

 

Takk for hjelpen

Lenke til kommentar

AMI BIOS Beep Codes

 

1 Short Beep One beep is good! Everything is ok, that is if you see things on the screen. If you don't see anything, check your monitor and video card first. Is everything connected? If they seem fine, your motherboard has some bad chips on it. First reset the SIMM's and reboot. If it does the same thing, one of the memory chips on the motherboard are bad, and you most likely need to get another motherboard since these chips are soldered on.

2 Short Beeps Your computer has memory problems. First check video. If video is working, you'll see an error message. If not, you have a parity error in your first 64K of memory. First check your SIMM's. Reseat them and reboot. If this doesn't do it, the memory chips may be bad. You can try switching the first and second banks memory chips. First banks are the memory banks that your CPU finds its first 64K of base memory in. You'll need to consult your manual to see which bank is first. If all your memory tests good, you probably need to buy another motherboard.

3 Short Beeps Basically the same thing as 2 beeps. Follow that diagnosis above.

4 Short Beeps Basically the same thing as 2 beeps. Follow that diagnosis above. It could also be a bad timer

5 Short Beeps Your motherboard is complaining. Try reseating the memory and rebooting. If that doesn't help, you should consider another motherboard. You could probably get away with just replacing the CPU, but that's not too cost-effective. Its just time to upgrade!

6 Short Beeps The chip on your motherboard that controls your keyboard (A20 gate) isn't working. First try another keyboard. If it doesn't help, reseat the chip that controls the keyboard, if it isn't soldered in. If it still beeps, replace the chip if possible. Replace the motherboard if it is soldered in.

7 Short Beeps Your CPU broke overnight. Its no good. Either replace the CPU, or buy another motherboard.

8 Short Beeps Your video card isn't working. Make sure it is seated well in the bus. If it still beeps, either the whole card is bad or the memory on it is. Best bet is to install another video card.

9 Short Beeps Your BIOS is bad. Reseat or Replace the BIOS.

10 Short Beeps Your problem lies deep inside the CMOS. All chips associated with the CMOS will likely have to be replaced. Your best bet is to get a new motherboard.

11 Short Beeps Your problem is in the Cache Memory chips on the motherboard. Reseat or Replace these chips.

1 Long, 3 Short Beeps You've probably just added memory to the motherboard since this is a conventional or extended memory failure. Generally this is caused by a memory chip that is not seated properly. Reseat the memory chips.

1 Long, 8 Short Beeps Display / retrace test failed. Reseat the video card.

 

 

 

Phoenix BIOS Beep Codes

These audio codes are a little more detailed then the AMI codes. This BIOS emits three sets of beeps. For example, 1 -pause- 3 -pause 3 -pause. This is a 1-3-3 combo and each set of beeps is separated by a brief pause. Listen to this sequence of sounds, count them, and reboot and count again if you have to.

 

1-1-3 Your computer can't read the configuration info stored in the CMOS. Replace the motherboard.

1-1-4 Your BIOS needs to be replaced.

1-2-1 You have a bad timer chip on the motherboard. You need a new motherboard.

1-2-2 The motherboard is bad.

1-2-3 The motherboard is bad.

1-3-1 You'll need to replace the motherboard.

1-3-3 You'll need to replace the motherboard.

1-3-4 The motherboard is bad.

1-4-1 The motherboard is bad.

1-4-2 Some of your memory is bad.

2-_-_ Any combo of beeps after two means that some of your memory is bad, and unless you want to get real technical, you should probably have the guys in the lab coats test the memory for you. Take it to the shop.

3-1-_ One of the chips on your motherboard is broken. You'll likely need to get another board.

3-2-4 One of the chips on your motherboard that checks the keyboard is broken. You'll likely need to get another board.

3-3-4 Your computer can't find the video card. Is it there? If so, try swapping it with another one and see if it works.

3-4-_ Your video card isn't working. You'll need to replace it.

4-2-1 There's a bad chip on the motherboard. You need to buy another board.

4-2-2 First check the keyboard for problems. If nothing, you have a bad motherboard.

4-2-3 Same as 4-2-2.

4-2-4 One of the cards is bad. Try yanking out the cards one by one to isolate the culprit. Replace the bad one. The last possibility is to buy another motherboard.

4-3-1 Replace the motherboard.

4-3-2 See 4-3-1

4-3-3 See 4-3-1

4-3-4 Time of day clock failure. Try running the setup program that comes with the computer. Check the date and time. If that doesn't work, replace the battery. If that doesn't work, replace the power supply. You may have to replace the motherboard, but that is rare.

4-4-1 Your serial ports are acting up. Reseat, or replace, the I/O card. If the I/O is on the motherboard itself, disable them with a jumper (consult your manual to know which one) and then add an I/O card.

4-4-2 See 4-4-1, but this time is your Parallel port that's acting up.

4-4-3 You math coprocessor is having problems. Run a test program to double-check it. If it is indeed bad, disable it, or replace it.

Low 1-1-2 Your motherboard is having problems

Low 1-1-3 This is an Extended CMOS RAM problem, check your motherboard battery, and motherboard.

Lenke til kommentar

Opprett en konto eller logg inn for å kommentere

Du må være et medlem for å kunne skrive en kommentar

Opprett konto

Det er enkelt å melde seg inn for å starte en ny konto!

Start en konto

Logg inn

Har du allerede en konto? Logg inn her.

Logg inn nå
×
×
  • Opprett ny...