BIOS

[SoftChIP]

Hei!

 

PCEN min:::::

 

Abit KX7-333R hovedkort

 

AMD AthlonXP 1900+

 

512MB DDR 2100 minne

 

3D prophet All In Wonder 7500 skjermkort

 

+mye mere

 

*********************************************

 

Vanlig prosessor temperatur: 54C

 

*********************************************

 

BIOSen min:

 

CPU Operating Speed *** 1900+(133)

CPU FSB Clock(MHz) *** 133

Ratio (FSB:AGP:PCI) *** 4:2:1

Multplier Factor *** x12

Enhance For Benchmark *** Disabled

Speed Error Hold *** Disabled

CPU Power Supply *** CPU Default

Core Voltage *** 1,750V

|/0 Voltage *** 3,50V

DDR Voltage *** 2,55V

CPU Fast Command Decode *** Normal

 

*****************************************

 

Spørsmålet mitt er da.....:

 

Hva burde jeg gjøre her for å få en raskere prosessor???

Jeg vil ikke ta store sjangser......

Bare kom med forslag....

 

Er det noe "fysisk" jeg MÅ gjøre?

 

SoftChIP

[Jarmo]

svarte på den andre posten din på samme spm !

[Villmink]

Du kan jo prøve:

 

!!! WARNING !!! Not every DDR memory module can work with the following aggressive setting. !!! WARNING !!!

 

Load Optimized Defaults

SoftMenu III Setup

2-1 CPU Operation Speed: User Define

Enhance For Benchmark: Enabled

2-2 CPU Fast Command Decode:

Ultra (for 100 and 133 CPU)

Fast (for CPU overclocked to 166 and above)

Advanced BIOS Features

3-1 CPU L2 Cache ECC Checking: Disabled

3-2 APIC Mode: Enabled

Advanced Chipset Features/DRAM Clock

4-1. DRAM Timing: Manual

DRAM CAS Latency: 2

Bank Interleave: 4 Bank

Precharge to active(Trp): 2T

Active to Precharge(Tras): 5T

Active to CMD(Trcd): 2T

(If the system fails to boot up with above five settings, clear CMOS by yellow jumper and load optimized default)

4-2. DIMM1&2 CMD Drive Strength: High (For Kingmax DDR module compatibility only; keeps Auto for other DDR modules)

DIMM3&4 CMD Drive Strength: High (For Kingmax DDR module compatibility only; keeps Auto for other DDR modules)

4-3. Enhance DRAM Performance: Enabled

4-4. DRAM Access: 2T

(If the system fails to boot up with above 2T setting, clear CMOS by yellow jumper and load optimized default)

4-5. DRAM Command Rate: 1T Command

(1T Command is a big challenge to most DDR modules, but if your module survived on this setting, there will be a significant memory performance gain.)

Advanced Chipset Features/AGP & P2P Bridge Control

5-1. AGP Aperture Size: 128M

5-2. AGP Driving Control: Manual

AGP Driving Value: DA or EC

5-3. Enhance AGP Performance: Enabled

 

Det hjalp endel på mitt Abit KX7-333 (ikke raid, men tror ikk det skal ha noe å si) Mulig du må droppe de småagressive instillingene på ram'n dersom du har billigram.

[SoftChIP]

Åssen cpu og ram har du....?????

[Villmink]

Jeg har XP 2400+ (T-bred) og 1GB noname ram. Dette hjalp også tidligere da jeg hade 512MB Ram og XP 1800 (palomino)