Gå til innhold

G.Skill Trident Z DDR4 RGB, kan ikke endre RGB.


Malmern

Anbefalte innlegg

Hei.

Sliter litt med å endre farge / mønster på de innebygde RGBene i RAM-brikkene.

Har prøvd Mystic Light og G. Skill sin egen software uten hell,
dvs. det virker som at fargen/mønstret endrer seg i noen få sekunder før den går tilbake til standard farge/mønster,
det samme gjelder viss jeg prøver å slå av RGBene, de er av i noen få sekunder før de skrur seg på igjen. 😕

Har prøvd å reinnstallere Mystic Light uten hell,
har også prøvd å følge en guide som skal fikse problemet:


 

1.       Uninstall Trident Z Lighting Control (from Windows Add/Remove Program)

2.       Reboot after the uninstall

3.       Uninstall all other lighting control software (e.g. Asus Aura, MSI Mystic Light, Gigabyte RGB Fusion, ASRock Polychrome) from Windows Add/Remove Program

4.       Reboot after each uninstall

5.       Download this batch file: http://www.gskill.com/gskill-device/memory/tzrgb_fix/aac-driver-full-remove-v1.1.bat.zip

Extract the aac-driver-full-remove-v1.1.bat file from the ZIP file to the desktop, and double click on the batch (BAT) file. Wait until it completes the uninstallation of the driver files.

Press any key to exit, or wait 30 seconds for the dialogue to close.
Windows may show a warning message when executing or extracting this batch file. If you do see this warning message, please right click on the ZIP file, click on "Properties", check "Unblock" on the bottom, and click “OK”.

6.       Go to C:\Windows\System32\drivers folder, and then check if “ene.sys” file is present.

a.       If “ene.sys” file does not exist, then you are finished with the uninstall process.

b.      If “ene.sys” file is present, please reboot the system into safe mode, and then go to the same folder and delete the “ene.sys” file.

7.       Install only one lighting control software to see if your system would be able to detect and control your memory kit.


Denne metoden fungerer fint frem til jeg starter PCen på nytt igjen,
da kommer "ene.sys" tilbake...

Lenke til kommentar
Videoannonse
Annonse

Opprett en konto eller logg inn for å kommentere

Du må være et medlem for å kunne skrive en kommentar

Opprett konto

Det er enkelt å melde seg inn for å starte en ny konto!

Start en konto

Logg inn

Har du allerede en konto? Logg inn her.

Logg inn nå
  • Hvem er aktive   0 medlemmer

    • Ingen innloggede medlemmer aktive
×
×
  • Opprett ny...