nettverksproblem i redhat9.0

[neXon]

Har nettop fått installert redhat 9.0 men nettverket vil ikke fungere, ser at det ikke er installert noen nettverks kort inne på "nettverkskonfigurasjon". Prøvde og legge til nettverkskortet mannuelt men kortet står ikke på på listen, det er eit Intigrert "Realtek 8201AL PHY" hvordan skal jeg få fikset dette?

 

(Er ingen ekspert i linux for å få det sakt )

[BlueEAGLE]

Har du prøvd alle realtek driverene?

[neXon]

har testet med alle tre kortene som står på listen, når jeg prøver og aktivere kortet får jeg bare "Kan ikke aktivere eth1, eth1 ser ikke til og være tilstede, venter med intigritering"

[neXon]

ingen? må løse dette raskest mulig :-? sitter på jobb

[GNUfan]

ingen? må løse dette raskest mulig :-? sitter på jobb

Slutten av dmesg kan hjelpe oss litt.

kjør dmesg i en kommandolinje.

[neXon]

okay, får opp masse jeg ikke forstår so mye av, men siden jeg ikke har nettverk/internett på den maskinen så må jeg få tekst filen over på en diskett, så der kommer neste problem....hehe finner F*** ikke ut hvordan man finner/kommer inn på disketten. Må han mounte den eller noe? :-?

[GNUfan]

mount /mnt/floppy && cd /mnt/floppy && dmesg > dmesg.out && cd .. && umount floppy

bare skriv hele linja(med &&-ene) og vips så har du en diskett som inneholder fila dmesg.out som inneholder infoen vi trenger. Mens du er i gang så kan du også poste outputten av en 'ifconfig' (uten '-ene).

[neXon]

Linux version 2.4.20-8 ([email protected]) (gcc version 3.2.2 20030222 (Red Hat Linux 3.2.2-5)) #1 Thu Mar 13 17:18:24 EST 2003

BIOS-provided physical RAM map:

BIOS-e820: 0000000000000000 - 0000000000080000 (usable)

BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)

BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)

BIOS-e820: 0000000000100000 - 000000000dfec000 (usable)

BIOS-e820: 000000000dfec000 - 000000000dfef000 (ACPI data)

BIOS-e820: 000000000dfef000 - 000000000dfff000 (reserved)

BIOS-e820: 000000000dfff000 - 000000000e000000 (ACPI NVS)

BIOS-e820: 00000000fec00000 - 00000000fec01000 (reserved)

BIOS-e820: 00000000fee00000 - 00000000fee01000 (reserved)

BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)

0MB HIGHMEM available.

223MB LOWMEM available.

On node 0 totalpages: 57324

zone(0): 4096 pages.

zone(1): 53228 pages.

zone(2): 0 pages.

Kernel command line: ro root=LABEL=/

Initializing CPU#0

Detected 1302.964 MHz processor.

Console: colour VGA+ 80x25

Calibrating delay loop... 2601.77 BogoMIPS

Memory: 220788k/229296k available (1312k kernel code, 6208k reserved, 996k data, 128k init, 0k highmem)

Dentry cache hash table entries: 32768 (order: 6, 262144 bytes)

Inode cache hash table entries: 16384 (order: 5, 131072 bytes)

Mount cache hash table entries: 512 (order: 0, 4096 bytes)

Buffer-cache hash table entries: 16384 (order: 4, 65536 bytes)

Page-cache hash table entries: 65536 (order: 6, 262144 bytes)

CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)

CPU: L2 Cache: 64K (64 bytes/line)

Intel machine check architecture supported.

Intel machine check reporting enabled on CPU#0.

CPU: After generic, caps: 0383fbff c1c3fbff 00000000 00000000

CPU: Common caps: 0383fbff c1c3fbff 00000000 00000000

CPU: AMD Duron Processor stepping 01

Enabling fast FPU save and restore... done.

Enabling unmasked SIMD FPU exception support... done.

Checking 'hlt' instruction... OK.

POSIX conformance testing by UNIFIX

mtrr: v1.40 (20010327) Richard Gooch ([email protected])

mtrr: detected mtrr type: Intel

PCI: PCI BIOS revision 2.10 entry at 0xf1b20, last bus=2

PCI: Using configuration type 1

PCI: Probing PCI hardware

PCI: Using IRQ router default [10de/01b2] at 00:01.0

isapnp: Scanning for PnP cards...

isapnp: No Plug & Play device found

Linux NET4.0 for Linux 2.4

Based upon Swansea University Computer Society NET3.039

Initializing RT netlink socket

apm: BIOS version 1.2 Flags 0x03 (Driver version 1.16)

Starting kswapd

VFS: Disk quotas vdquot_6.5.1

pty: 2048 Unix98 ptys configured

Serial driver version 5.05c (2001-07-08) with MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI ISAPNP enabled

ttyS0 at 0x03f8 (irq = 4) is a 16550A

ttyS1 at 0x02f8 (irq = 3) is a 16550A

Real Time Clock Driver v1.10e

Floppy drive(s): fd0 is 1.44M

FDC 0 is a post-1991 82077

NET4: Frame Diverter 0.46

RAMDISK driver initialized: 16 RAM disks of 4096K size 1024 blocksize

Uniform Multi-Platform E-IDE driver Revision: 7.00beta-2.4

ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx

NFORCE: IDE controller at PCI slot 00:09.0

NFORCE: chipset revision 195

NFORCE: not 100% native mode: will probe irqs later

ide0: BM-DMA at 0xb800-0xb807, BIOS settings: hda:DMA, hdb:pio

ide1: BM-DMA at 0xb808-0xb80f, BIOS settings: hdc:DMA, hdd:pio

hda: SAMSUNG CD-ROM SC-152A, ATAPI CD/DVD-ROM drive

hdc: WDC WD400BB-00DEA0, ATA DISK drive

blk: queue c03bed60, I/O limit 4095Mb (mask 0xffffffff)

ide0 at 0x1f0-0x1f7,0x3f6 on irq 14

ide1 at 0x170-0x177,0x376 on irq 15

hdc: host protected area => 1

hdc: 78165360 sectors (40021 MB) w/2048KiB Cache, CHS=77545/16/63, UDMA(33)

ide-floppy driver 0.99.newide

Partition check:

hdc: hdc1 hdc2 hdc3

ide-floppy driver 0.99.newide

md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27

md: Autodetecting RAID arrays.

md: autorun ...

md: ... autorun DONE.

NET4: Linux TCP/IP 1.0 for NET4.0

IP Protocols: ICMP, UDP, TCP, IGMP

IP: routing cache hash table of 2048 buckets, 16Kbytes

TCP: Hash tables configured (established 16384 bind 32768)

Linux IP multicast router 0.06 plus PIM-SM

NET4: Unix domain sockets 1.0/SMP for Linux NET4.0.

RAMDISK: Compressed image found at block 0

Freeing initrd memory: 146k freed

VFS: Mounted root (ext2 filesystem).

Journalled Block Device driver loaded

kjournald starting. Commit interval 5 seconds

EXT3-fs: mounted filesystem with ordered data mode.

Freeing unused kernel memory: 128k freed

usb.c: registered new driver usbdevfs

usb.c: registered new driver hub

PCI: Setting latency timer of device 00:02.0 to 64

usb-ohci.c: USB OHCI at membase 0xce849000, IRQ 10

usb-ohci.c: usb-00:02.0, PCI device 10de:01c2 (nVidia Corporation)

usb.c: new USB bus registered, assigned bus number 1

hub.c: USB hub found

hub.c: 3 ports detected

PCI: Setting latency timer of device 00:03.0 to 64

usb-ohci.c: USB OHCI at membase 0xce84b000, IRQ 10

usb-ohci.c: usb-00:03.0, PCI device 10de:01c2 (nVidia Corporation)

usb.c: new USB bus registered, assigned bus number 2

hub.c: USB hub found

hub.c: 3 ports detected

usb.c: registered new driver hiddev

usb.c: registered new driver hid

hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik <[email protected]>

hid-core.c: USB HID support drivers

mice: PS/2 mouse device common for all mice

EXT3 FS 2.4-0.9.19, 19 August 2002 on ide1(22,2), internal journal

Adding Swap: 458632k swap-space (priority -1)

kjournald starting. Commit interval 5 seconds

EXT3 FS 2.4-0.9.19, 19 August 2002 on ide1(22,1), internal journal

EXT3-fs: mounted filesystem with ordered data mode.

parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE]

parport0: irq 7 detected

ip_tables: © 2000-2002 Netfilter core team

spurious 8259A interrupt: IRQ7.

parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE]

parport0: irq 7 detected

lp0: using parport0 (polling).

lp0: console ready

ide-floppy driver 0.99.newide

hda: ATAPI 52X CD-ROM drive, 128kB Cache, DMA

Uniform CD-ROM driver Revision: 3.12

cdrom: This disc doesn't have any tracks I recognize!

udf: registering filesystem

UDF-fs DEBUG lowlevel.c:57:udf_get_last_session: XA disk: no, vol_desc_start=0

UDF-fs DEBUG super.c:1421:udf_read_super: Multi-session=0

UDF-fs DEBUG super.c:410:udf_vrs: Starting at sector 16 (2048 byte sectors)

UDF-fs DEBUG super.c:437:udf_vrs: ISO9660 Primary Volume Descriptor found

UDF-fs DEBUG super.c:440:udf_vrs: ISO9660 Supplementary Volume Descriptor found

UDF-fs DEBUG super.c:446:udf_vrs: ISO9660 Volume Descriptor Set Terminator found

UDF-fs: No VRS found

ISO 9660 Extensions: Microsoft Joliet Level 3

ISOFS: changing to secondary root

[neXon]

og med ifconfig får jeg dette:

 

lo Link encap:Local Loopback

inet addr:127.0.0.1 Mask:255.0.0.0

UP LOOPBACK RUNNING MTU:16436 Metric:1

RX packets:26675 errors:0 dropped:0 overruns:0 frame:0

TX packets:26675 errors:0 dropped:0 overruns:0 carrier:0

collisions:0 txqueuelen:0

RX bytes:1828115 (1.7 Mb) TX bytes:1828115 (1.7 Mb)

[GNUfan]

rart...

det står absolutt INGENTING som har noe med nettverksdrivere...

[neXon]

hmmm, kan det vere fordi at det ikke er installert noe kort? er det ingen plass på nettet jeg kan finne drivere til dette kortet? google fant lite

[neXon]

okay, har endelig fått til internett på den

Jeg tok og satt i eit Unex kort, det rare var at under oppstarten så fant den plutselig Realtek kortet, så jeg konfigurerte det. Når jeg kom inn i redhat kunne jeg pinge og alt fungerte fint, så jeg tenkte "da kan jeg ta ut unex kortet igjen" men neida. I redhat står det at det er realtek kortet som er installert, men det er unex kortet som blir brukt jaja...er greit det, bare det fungerer