I Tawt I Taw a Puddy Tat - Nesten ferdig/ferdig? (side 4)

[Fuglefaen]

Poster direkte fra et annet forum siden jeg er for lat til å poste 2 ganger i dag

 

Started back up and leaktested.

Had 3 leaks

If only all leaks was at the same time :think: :facepalm:

 

The leak was 3 defect fittings. Probably since I reused most of the fittings.

After draining the system 3 times and changed the bad fittings it now seams leak free

 

It's getting close to be done now :thumbsup:

Some wireing still to be done, need to reconnect the Power and Reset button.

 

Going to change 2 fans thats making to much noise. 

Probably some more things I've forgotten to do :think:

 

Since it has a raw industrial look I would have liked to use metall tubing.

But since I had no fittings or tubing for that, but alot of soft tubing and fittings I figured I would use that to save some cash 8-)

 

EDIT: Pictures aren't any good. Don't have my camera here. So used the phone......

 

Defective fittings

 

After 3 years of running without changing water or changing thermal paste i figured it was time to clean the CPU water block :wave:

 

After

 

 

 

 

 

Time to do some OC again (downclocked when it was out of the case). Going to test more later with OC. But for now it runs stable at 4400MHz.

Runned Prime95 for 4 hours. Temps maxed out at 65 C.

 

The first time with all sides on the case :eh::wave:

The plexiglas was cut and made ready 3 years ago...... Has since live in the garage....

Actually looked better than I thougth it would.